Fixture Installation Instructions E

Instal5.jpg

Mounting Hardware ("A") & ("B") for Stucco or Concrete

1. Position the fixture on the wall in the desired position so that it covers the electrical box.

2. With a pencil, mark the location of the holes in the fixture that will accept the mounting bolts ("A").

3. Drill a hole in the wall big enough to accept the wall anchor ("B"). 

4. Insert the wall anchors ("B") into the holes drilled into the wall.

5. Holding the fixture close to the electrical box, connect the fixture wires to the house wiring. If your fixture has a bare ground wire, connect it as appropriate for your house wiring (Click here for those instructions).

6. Align the holes in the fixture that will accept the mounting bolts ("A") over the wall anchors ("B") already inserted into the wall.

7.Finally, thread each of the mounting bolts ("A") through its respective hole in the fixture into its respective wall ("B") anchor in the wall. Tighten the bolts ("A") until the fixture fits loosely up to the wall. Do a final alignment of the fixture and then tighten the bolts ("A") until the fixture is tight up against the wall.

Mounting Hardware ("C") & ("D") for Plaster or Drywall

1. Position the fixture on the wall in the desired position so that it covers the electrical box.

2. With a pencil, mark the location of the holes in the fixture that will accept the mounting screws ("C").  

3. Drill a hole in the wall big enough for the wall anchor ("D") to pass through in its closed position.

4. Thread the mounting screws ("C") through the respective holes in the fixture and into the respective wall anchors ("D")

5. Holding the fixture close to the electrical box, connect the fixture wires to the house wiring. If your fixture has a bare ground wire, connect it as appropriate for your house wiring (Click here for those instructions).

6. Align the wall anchors ("D"), already attached to the mounting screws ("C") with the holes drilled into the wall.  Close the wall anchors ("D") and push them deep enough into the wall so that they open up. 

7.Finally, place the fixture snugly up against the wall and tighten the mounting screws ("C") so that the fixture fits loosely up against the wall. Do a final alignment of the fixture and then tighten the screws ("A") until the fixture is tight up against the wall.